LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Fuel System - Service Information (1 Of 2)) >> Fuel Pressure Sensor >> Installation [08/2023 - ] >> Procedure

Installation [08/2023 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL NO. 2 FUEL PRESSURE SENSOR 
    1. GTY1192682Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 No. 2 Fuel Pressure Sensor *2 No. 2 Fuel Pressure Sensor Holder
      *a Flat - -
      1. Install a new No. 2 fuel pressure sensor to the No. 2 fuel pressure sensor holder as shown in the illustration.
  2. INSTALL NO. 2 FUEL PRESSURE SENSOR HOLDER 
    1. GTY1074228Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using an 8 mm socket wrench, install the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.

        Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

      2. Connect the No. 2 fuel pressure sensor connector.
  3. INSTALL FUEL PUMP LIFTER ASSEMBLY 
    Refer to PROCEDURE - Step 1
  4. INSTALL FUEL PUMP SPACER GASKET 
  5. TEMPORARILY INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY 
    Refer to PROCEDURE - Step 3
  6. TEMPORARILY INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 4
  7. INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY 
    Refer to PROCEDURE - Step 5
  8. INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 6
  9. CONNECT FUEL TUBE SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 7
  10. INSTALL FUEL PIPE CLAMP 
  11. INSTALL NO. 2 WATER BY-PASS PIPE 
    Refer to PROCEDURE - Step 6
  12. INSTALL EGR VALVE ASSEMBLY 

    Refer to INSTALLATION [08/2023 - ]

  13. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY 

    Refer to INSTALLATION [08/2023 - ]

  14. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 5

  15. INSTALL BATTERY SERVICE COVER PLATE 
  16. INSPECT FOR FUEL LEAK 

    Refer to PROCEDURE - Step 1

  17. INSPECT FOR ENGINE OIL LEAK 

    Refer to PROCEDURE - Step 6

  18. PERFORM INITIALIZATION 
    1. Perform "Inspection After Repair" after replacing a No. 2 fuel pressure sensor.

      Refer to INITIALIZATION [10/2022 - ]

  19. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL 

    Refer to WORK PROCEDURE [10/2022 - ]

    HINT: 

    When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

    Refer to AUTOMATIC LEARNING CHART [08/2023 - ]

scientia non olet · About LEMON Manuals