Inspection [10/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT OIL PRESSURE AND TEMPERATURE SENSOR
- Check the oil pressure and temperature sensor output voltage.
- Apply 5 V between terminals 3 (VC) and 2 (GND).
*a Component without harness connected
(Oil Pressure and Temperature Sensor)*b Voltage Applied between Terminals NOTE:- Be careful when connecting the leads as the oil pressure and temperature sensor may be damaged if the leads are connected to the wrong terminals.
- Do not apply more than 6 V to terminals 3 (VC) or 2 (GND).
HINT:
If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.
- Measure the voltage between terminals.
*a Component without harness connected
(Oil Pressure and Temperature Sensor)Standard Voltage
Tester Connection Condition Specified Condition 4 (TOUT) - 2 (GND) 20°C (68°F) Approximately 1.5 to 2.5 V* *: The output voltage changes depending on the voltage applied to the terminals.
If the result is not as specified, replace the oil pressure and temperature sensor.
- Apply 5 V between terminals 3 (VC) and 2 (GND).
- Check the oil pressure and temperature sensor output voltage.