LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Control System - Diagnostic Codes (P0195-P0335)) >> SFI System >> DTC P0335-2A: Crankshaft Position Sensor "A" Signal Stuck in Range; DTC P0335-31: Crankshaft Position Sensor "A" No Signal [10/2022 - 08/2023] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
ALL

Both of the following conditions are met -
Hybrid control module judge Engine running
Lost communication with hybrid vehicle control ECU assembly (U0293) Not detected
P0335 (CASE 1)

All of the following conditions are met -
Auxiliary battery voltage Higher than 6 V
Crankshaft position sensor voltage 0.3 to 4.7 V
Ignition switch On
P0335 (CASE 2)

All of the following conditions are met -
Auxiliary battery voltage Higher than 6 V
Crankshaft position sensor voltage 0.3 to 4.7 V
Starter Off
Engine speed (Top dead center) 600 rpm or higher
Engine speed (30°CA) 600 rpm or higher