DTC P06A0-14: Compressor Solenoid Circuit Short to Ground or Open [10/2022 - ]: Procedure

1. Read the Data List according to the display on the GTS.

   Body Electrical > Air Conditioner > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Solenoid Valve Control Current Value	Solenoid valve control current	Min.: 0 mA Max.: 1000 mA	Value changes between 0 A and 0.997 A in accordance with solenoid valve operation	-

   Body Electrical > Air Conditioner > Data List 

   Tester Display
   Solenoid Valve Control Current Value

   OK

   The display is as specified in the normal condition column.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY. Refer to  REMOVAL [10/2022 - ] 

Result: 

NG 

See step  2

Pre-procedure1

• Disconnect the B32 compressor assembly with pulley connector.

• Measure the resistance according to the value(s) in the table below.

  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

  *a	Component without harness connected (Compressor Assembly with Pulley)

  Standard Resistance

  Tester Connection	Condition	Specified Condition	Result
  1 (SOL-) - 2 (SOL+)	Compressor temperature 25°C (77°F)	10.1 to 11.1 Ω	Ω

  Result

  Proceed to
  OK
  NG

Post-procedure1

• None

Result: 

NG 

REPLACE COMPRESSOR ASSEMBLY WITH PULLEY. Refer to  REMOVAL [10/2022 - ] 

Result: 

OK 

See step  3

Pre-procedure1

• Disconnect the B32 compressor assembly with pulley connector.
• Disconnect the C47 air conditioning amplifier assembly connector.

• Measure the resistance according to the value(s) in the table below.

  Standard Resistance

  Tester Connection	Condition	Specified Condition	Result
  B32-2 (SOL+) - C47-18 (SOL+)	Always	Below 1 Ω	Ω
  B32-1 (SOL-) - Body ground	Always	Below 1 Ω	Ω
  B32-2 (SOL+) or C47-18 (SOL+) - Other terminals and body ground	Always	10 kΩ or higher	kΩ

  Result

  Proceed to
  OK
  NG

Post-procedure1

• None

Result: 

OK 

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY. Refer to  REMOVAL [10/2022 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR