LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Engine Control System - Diagnostic Codes (P050B-P06AB)) >> SFI System >> DTC P05A2-12: Active Grille Air Shutter "A" Circuit Short to Battery [10/2022 - ] >> Procedure

DTC P05A2-12: Active Grille Air Shutter "A" Circuit Short to Battery [10/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM UTILITY USING GTS (SWITCH GRILLE SHUTTER CONTROL MODE) 

    Pre-procedure1

    • Turn the ignition switch off and wait for 30 seconds or more.
    • According to the display on the GTS, change the grille shutter control mode from normal mode to maintenance mode.

      Powertrain > Engine > Utility 

      Tester Display
      Switch Grille Shutter Control Mode

      Result

      Proceed to
      NEXT

    Post-procedure1

    • None.

    Result: 

    NEXT 

    See step  2

  2. PERFORM UTILITY USING GTS (GRILLE SHUTTER INITIALIZATION) 
    1. According to the display on the GTS, perform initialization (nominal torque).

      Powertrain > Engine > Utility 

      Tester Display
      Grille Shutter Initialization

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  3

  3. CLEAR DTC 

    Pre-procedure1

    • None.
    • Clear the DTCs.

      Powertrain > Engine > Clear DTCs 

      Result

      Proceed to
      NEXT

    Post-procedure1

    • Turn the ignition switch off and wait for at least 30 seconds.

    Result: 

    NEXT 

    See step  4

  4. CHECK DTC OUTPUT (DTC P05A2-12) 

    Pre-procedure1

    • Turn the ignition switch to ON and wait 10 seconds or more.
    • Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      P05A2-12 is not output A
      P05A2-12 is output B

      HINT: 

      Perform "Switch Grille Shutter Control Mode and Grille Shutter Initialization" after replacing the radiator shutter assembly.

      Refer to INITIALIZATION [10/2022 - ]

    Post-procedure1

    • None.

    Result: 

    REPLACE RADIATOR SHUTTER ASSEMBLY. Refer to  REMOVAL [10/2022 - ] 

    Result: 

    See step  5

  5. READ VALUE USING GTS (GRILLE SHUTTER CONTROL MODE) 

    Pre-procedure1

    • According to the display on the GTS, change the grille shutter control mode from maintenance mode to normal mode.

      Powertrain > Engine > Utility 

      Tester Display
      Switch Grille Shutter Control Mode
    • Read the value displayed on the GTS.

      Powertrain > Engine > Data List 

      Tester Display
      Grille Shutter Control Mode

      Standard

      GTS Display Specified Condition
      Grille Shutter Control Mode Normal

      Result

      Proceed to
      NEXT

    Post-procedure1

    • None.

    Result: 

    NEXT 

    END