Inspection [10/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT POWER SWITCH
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Power Switch)Standard Resistance
Tester Connection Condition Specified Condition Result 12 (SS1) - 3 (GND)
6 (SS2) - 3 (GND)
11 (SS3) - 3 (GND)Not pushed 10 kΩ or higher kΩ 12 (SS1) - 3 (GND)
6 (SS2) - 3 (GND)
11 (SS3) - 3 (GND)Pushed Below 1 Ω Ω If the result is not as specified, replace the power switch.
- Measure the resistance according to the value(s) in the table below.
- Check the LED illumination.
- Apply auxiliary battery voltage between the terminals of the power switch and check the illumination condition of the power switch indicator light.
*a Component without harness connected
(Power Switch)OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 5 (SWIL)
Auxiliary battery negative (-) → Terminal 3 (GND)Illuminates If the result is not as specified, replace the power switch.
- Apply auxiliary battery voltage between the terminals of the power switch and check the illumination condition of the power switch indicator light.
- Check the resistance.