LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 ( Automatic Transaxle System - Diagnostic Codes (3 Of 3) & Circuit Tests) >> Automatic Transaxle System >> DTC U1103-87: Lost Communication with Stop and Start Control Module Missing Message [10/2022 - ] >> Confirmation Driving Pattern

Confirmation Driving Pattern

WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.

HINT: 

After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

  1. Turn the ignition switch to ON and turn the GTS on.
  2. Wait for 3 seconds or more with the ignition switch ON.
  3. Enter the following menus: Powertrain / Transmission / Utility / All Readiness.
  4. Input the DTC: U1103-87.
  5. Check the DTC judgment result.

    HINT: 

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE or N/A, perform the Confirmation Driving Pattern and check the DTC judgment result again.