LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Automatic Transaxle System - Diagnostic Codes (2 Of 3)) >> Automatic Transaxle System >> DTC P2713-14: Pressure Control Solenoid "D" Circuit Short to Ground or Open [10/2022 - ] >> Confirmation Driving Pattern

Confirmation Driving Pattern

WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.

HINT: 

  1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  2. Turn the ignition switch off and wait for 2 minutes or more.
  3. Turn the ignition switch to ON and turn the GTS on.
  4. Start the engine.
  5. Wait for 2 seconds or more with the engine running. [*1]

    HINT: 

    [*1] : Normal judgment procedure.

    The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.

  6. Enter the following menus: Powertrain / Transmission / Utility / All Readiness.
  7. Input the DTC: P2713-14.
  8. Check the DTC judgment result.

    HINT: 

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE or N/A, perform the normal judgment procedure again.