DTC P176A-87: Lost Communication with Fail Safe Signal (Gear Shift Control Module "A") Missing Message [10/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (SHIFT CONTROL ECU - ECM)
Pre-procedure1
- Disconnect the C35 transmission floor shift assembly connector.
- Disconnect the A16 ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Result C35-19 (SBFS) - A16-62 (SBFS) Always Below 1 Ω Ω C35-19 (SBFS) or A16-62 (SBFS) - Body ground and other terminals Always 10 kΩ or higher kΩ Result
Proceed to OK NG
Post-procedure1
- None
Result:
OK
REPLACE SHIFT CONTROL ECU (TRANSMISSION FLOOR SHIFT ASSEMBLY). Refer to REMOVAL [10/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR