DTC P16B0-9F: Actuator Cut Circuit Stuck Off [10/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
- CLEAR DTC
- Clear the DTCs.
Powertrain > Transmission > Clear DTCs
HINT:
Write down the currently output DTCs before clearing them.
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Clear the DTCs.
- READ OUTPUT DTC (DTC P16B0-9F)
Pre-procedure1
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) battery terminal.
- Turn the ignition switch to ON and wait for 1 minute or more.
- Turn the ignition switch off and wait for 2 minutes or more.
HINT:
This DTC is detected after the ignition switch is turned off.
- Read the DTCs using the GTS.
Powertrain > Transmission > Trouble Codes
Result
Result Proceed to DTCs are not output A P16B0-9F is output B
Post-procedure1
- None
Result:
A
CHECK FOR INTERMITTENT PROBLEMS. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - ]
Result:
B
See step 3
- REPLACE ECM
HINT:
Refer to REMOVAL [10/2022 - ]
Result
Proceed to NEXT Result:
NEXT
PERFORM REGISTRATION. Refer to REGISTRATION [10/2022 - ]