Confirmation Driving Pattern

HINT: 

• After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the All Readiness check procedure.

  Refer to UTILITY [10/2022 - ]

• When clearing the permanent DTCs, refer to the Clear Permanent DTC procedure.

  Refer to DTC CHECK / CLEAR [10/2022 - ]

1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
2. Turn the ignition switch off and wait for 2 minutes or more.
3. Start the engine. [*1]
4. Depress the brake pedal and slowly change the shift state from N to R to N to D to M to the home position.
5. Press the P position switch to change the shift state to P.
6. Turn all switches off and turn the ignition switch off.
7. Disconnect the GTS.
8. Wait for 5 minutes or more with the door lock locked.

   HINT: 

   • Once the door lock is locked, keep the electrical key transmitter sub-assembly (electrical key) 3 m (9.84 ft.) or more away from the vehicle.
   • Because the system will not sleep while any door and/or the hood is open, take steps such as securing the courtesy switch to make the system recognize the doors and hood as closed when carrying out the operation.
   • If the vehicle is equipped with a power back door, the system will not sleep if the back door is not closed. Ensure that the back door is closed before carrying out the operation.
9. Start the engine.
10. Depress the brake pedal and slowly change the shift state from N to R to N to D to M to the home position.
11. Press the P position switch to change the shift state to P. [*2]

    HINT: 

    [*1] to [*2]: Normal judgment procedure.

    The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.

12. Enter the following menus: Powertrain / Transmission / Utility / All Readiness.
13. Check the DTC judgment result.

    HINT: 

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE, perform the normal judgment procedure again.