DTC P2182-11: Engine Coolant Temperature Sensor 2 Circuit Short to Ground [10/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING GTS (CHECK FOR SHORT IN WIRE HARNESS)
Pre-procedure1
- Disconnect the engine coolant temperature sensor (for cylinder head side) connector.
*1 Engine Coolant Temperature Sensor (for Cylinder Head Side) *2 ECM
- According to the display on the GTS, read the Data List.
Powertrain > Engine > Data List
Tester Display Coolant Temperature Sensor2 Result
Result Proceed to The value of Coolant Temperature Sensor2 is -40 °C A None of the above conditions are met B HINT:
-40°C (-40°F)
Post-procedure1
- None.
Result:
A
REPLACE ENGINE COOLANT TEMPERATURE SENSOR (FOR CYLINDER HEAD SIDE). Refer to REMOVAL [10/2022 - ]
Result:
B
See step 2
- Disconnect the engine coolant temperature sensor (for cylinder head side) connector.
- CHECK HARNESS AND CONNECTOR (ENGINE COOLANT TEMPERATURE SENSOR (FOR CYLINDER HEAD SIDE) - ECM)
Pre-procedure1
- Disconnect the engine coolant temperature sensor (for cylinder head side) connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Result V4-2 (THW2) or B27-79 (THW2) - Body ground and other terminals Always 10 kΩ or higher kΩ Result
Proceed to OK NG
Post-procedure1
- None.
Result:
OK
REPLACE ECM. Refer to REMOVAL [10/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR