LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Electronic A/T Shift Lever System - Diagnostic Codes (2 Of 2) & Circuit Tests) >> Electronic Shift Lever System >> DTC P18A6-00: Gear Shift Control Module "A"/"B" (Sub CPU) Ignition Switch On/Start Position Signal Compare Failure; DTC P18A6-62: Gear Shift Control Module "A"/"B" Ignition Switch On/Start Position Signal Compare Failure [10/2022 - 08/2023] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When removing or installing the shift control ECU and shift actuator ECU, make sure there is no power supplied*1 when disconnecting or connecting the connectors.

    *1: Battery, sub-battery, integrated capacitor, etc.

  • When disconnecting a wire harness of any component connected to the supply power of the integrated capacitor (integration control supply) or when removing the integrated capacitor (integration control supply), make sure to wait 5 minutes or more after turning the ignition switch off for self-diagnosis to complete and the voltage of the integrated capacitor (integration control supply) to discharge.
  • Before performing troubleshooting, check the fuses, connector connections and contact pressure of the relevant terminals for this circuit.
  • To prevent the key from being locked in the vehicle, make sure to enter e-latch inspection mode and enable the manual release handle before disconnecting the cable from the negative (-) battery terminal.

    Refer to INSPECTION MODE PROCEDURE [10/2022 - ]

scientia non olet · About LEMON Manuals