DTC P107A-11: Fuel Rail Pressure Sensor (Low) / Fuel Rail Pressure Sensor "B" Circuit Short to Ground [10/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR
HINT:
Make sure that the connector is properly connected. If it is not, securely connect it and check for DTCs again.
Pre-procedure1
- Disconnect the No. 2 fuel pressure sensor (for low pressure side) connector.
- Turn the ignition switch to ON.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition Result B66-1 (VC) - B66-3 (E2) Ignition switch ON 4.5 to 5.5 V V B66-2 (PFL) - B66-3 (E2) Ignition switch ON 4.4 to 5.6 V V
Pre-procedure2
- Turn the ignition switch off and wait for at least 30 seconds.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Result B66-1 (VC) - B66-2 (PFL) Ignition switch off 171 to 189 kΩ kΩ Result
Proceed to OK NG
Post-procedure1
- None.
Result:
OK
REPLACE NO. 2 FUEL PRESSURE SENSOR (FOR LOW PRESSURE SIDE). Refer to REMOVAL [10/2022 - ]
Result:
NG
See step 2
- CHECK HARNESS AND CONNECTOR (NO. 2 FUEL PRESSURE SENSOR (FOR LOW PRESSURE SIDE) - ECM)
Pre-procedure1
- Disconnect the No. 2 fuel pressure sensor (for low pressure side) connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Result B66-1 (VC) - B27-119 (VCPF) Always Below 1 Ω Ω B66-2 (PFL) or B27-121 (PFL) - Body ground and other terminals Always 10 kΩ or higher kΩ Result
Proceed to OK NG
Post-procedure1
- None.
Result:
OK
REPLACE ECM. Refer to REMOVAL [10/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR