Monitor Description

WARNING: This page is about a different car, the 2025 Lexus RX 350, 2024 Lexus RX 350, and 2023 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.

While the engine is being cranked, positive battery voltage is applied to terminal STA of the ECM. If the ECM detects the starter control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circuit. The ECM then illuminates the MIL and stores the DTC.

This monitor runs when the vehicle is driven at 20 km/h (12.43 mph) or more for 20 seconds or more.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	DTC Output from	Priority	Note
P0615-12	Starter Relay Circuit Short to Battery	All of the following conditions are met, and battery voltage of 10.5 V or higher is applied to the ECM for 20 seconds (1 trip detection logic): (a) The vehicle speed is 20 km/h (12.43 mph) or more. (b) The engine speed is 1000 rpm or higher. (c) The STA signal is on.	ST NO. 1 relay Starter relay (ST) circuit Engine stop and start ECU ECM	Comes on	Engine	A	SAE Code: P0617 DTC for Mexico Models: Applies