Confirmation Driving Pattern

HINT: 

• After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

  Refer to UTILITY [08/2023 - ]

• When clearing the permanent DTCs, refer to the "CLEAR PERMANENT DTC" procedure.

  Refer to DTC CHECK / CLEAR [08/2023 - ]

1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
2. Enter the following menus: Powertrain / Hybrid Control / Data List.[*1]
3. Check that "Hybrid/EV Battery SOC" shows 70% or less.[*2]
4. Turn the ignition switch off and wait for 2 minutes or more.[*3]
5. Connect the electric vehicle charger cable assembly, and plug-in charge the vehicle for at least 5 seconds.[*4]

   HINT: 

   [*1] to [*4]: Normal judgment procedure.

   The normal judgment procedure is used to complete DTC judgment and also used when clearing permanent DTCs.

6. Enter the following menus: Powertrain / HV Battery / Utility / All Readiness.
7. Check the DTC judgment result.

   HINT: 

   • If the judgment result shows NORMAL, the system is normal.
   • If the judgment result shows ABNORMAL, the system has a malfunction.
   • If the judgment result shows INCOMPLETE or N/A, perform the normal judgment procedure again.