DTC P2614-01: Camshaft Position Signal Output "A" General Electrical Failure [10/2022 - 08/2023]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
HINT:
Refer to REMOVAL [10/2022 - 08/2023]
Result
Proceed to NEXT Result:
NEXT
See step 2
- CLEAR DTC
Pre-procedure1
- None.
Post-procedure1
- Turn the ignition switch off and wait for at least 30 seconds.
Result:
NEXT
See step 3
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
Pre-procedure1
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A P2614-01 is output B
Post-procedure1
- None.
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [10/2022 - 08/2023]