DTC P2533-14: Ignition Switch On/Start Position Circuit Low Circuit Short to Ground or Open [08/2023 - ]: Procedure

1. Read the Data List.

   Powertrain > Engine > Data List 

   Tester Display
   IGR

   Result

   Result	Proceed to
   The value of IGR is ON	A
   None of the above conditions are met	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [10/2022 - ] 

Result: 

B 

See step  2

Pre-procedure1

• Disconnect the ECM connector.
• Turn the ignition switch to ON.

• Measure the voltage according to the value(s) in the table below.

  Standard Voltage

  Tester Connection	Switch Condition	Specified Condition	Result
  A15-14 (IGR) - Body ground	Ignition switch ON	11 to 14 V	V

  Result

  Proceed to
  OK
  NG

Post-procedure1

• None.

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [08/2023 - ] 

Result: 

NG 

See step  3

Pre-procedure1

• Disconnect the ECM connector.
• Disconnect the power distribution box assembly connector.

• Measure the resistance according to the value(s) in the table below.

  Standard Resistance

  Tester Connection	Condition	Specified Condition	Result
  A72-13 - A15-14 (IGR)	Always	Below 1 Ω	Ω
  A72-13 or A15-14 (IGR) - Body ground and other terminals	Always	10 kΩ or higher	kΩ

  Result

  Proceed to
  OK
  NG

Post-procedure1

• None.

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

Pre-procedure1

• Disconnect the power distribution box assembly connectors.

• Measure the resistance according to the value(s) in the table below.

  Standard Resistance

  Tester Connection	Condition	Specified Condition	Result
  C89-36 - Body ground	Always	Below 1 Ω	Ω
  C90-41 - Body ground	Always	Below 1 Ω	Ω

  Result

  Proceed to
  OK
  NG

Post-procedure1

• None.

Result: 

OK 

REPLACE POWER DISTRIBUTION BOX ASSEMBLY. Refer to  REMOVAL [08/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR