DTC P0011-00: Camshaft Position "A" - Timing Over-Advanced or System Performance Bank 1 [10/2022 - 08/2023]: Procedure
WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0011-00)
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to P0011-00 and other DTCs are output A P0011-00 is output B HINT:
If any DTCs other than P0011-00 are output, troubleshoot those DTCs first.
Result:
A
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2022 - 08/2023]
Result:
B
See step 2
- Read the DTCs.
- REPLACE CAMSHAFT TIMING GEAR ASSEMBLY
HINT:
Refer to REMOVAL [10/2022 - 08/2023]
Result
Proceed to NEXT Result:
NEXT
See step 3
- CLEAR DTC
- Remove the EFI NO. 1 fuse from the No. 1 engine room relay block and No. 1 junction block assembly and wait for at least 60 seconds.
HINT:
Clear the DTC without using the GTS.
- Reinstall the EFI NO. 1 fuse.
Result
Proceed to NEXT
Result:
NEXT
See step 4
- Remove the EFI NO. 1 fuse from the No. 1 engine room relay block and No. 1 junction block assembly and wait for at least 60 seconds.
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
Pre-procedure1
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A P0011-00 is output B
Post-procedure1
- None.
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [10/2022 - 08/2023]