Confirmation Driving Pattern

HINT: 

After a repair, check Monitor Status by performing the Key-Off Monitor Confirmation described below.

1. KEY-OFF MONITOR CONFIRMATION 
   1. Preconditions

      The monitor will not run unless:

      • The vehicle has been driven for 10 minutes or more (in a city area or on a freeway).
      • The fuel tank is less than 85% full.
      • The altitude is less than 2400 m (7872 ft).
      • The engine coolant temperature is between 4.4 and 35°C (40 and 95°F).
      • The intake air temperature is between 4.4 and 35°C (40 and 95°F).
      • The vehicle remains stationary (the vehicle speed is 0 km/h [0 mph]).
   2. Monitor Conditions
      1. Allow the engine to idle for at least 5 minutes.
      2. Turn the ignition switch off and wait for 6 hours (8 or 10.5 hours).

         HINT: 

         Do not start the engine until checking Monitor Status. If the engine is started, the steps described above must be repeated.

   3. Monitor Status
      1. Enter the following menus: Powertrain / Engine / Monitor / Current Monitor.
      2. Check the Monitor Status displayed on the GTS.

         HINT: 

         If Incomplete is displayed, the monitor did not complete. Make sure that the preconditions have been met, and perform the Monitor Conditions again.