DTC C1622-87: Rear Camera Image Signal Missing Message [10/2022 - ]: Procedure
- CHECK PARKING ASSIST MONITOR SYSTEM
- Check if the parking assist monitor system is malfunctioning.
HINT:
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - ]
Result
Result Proceed to Malfunction does not occur A Malfunction occurs B
Result:
B
GO TO PARKING ASSIST MONITOR SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - ]
Result:
A
See step 2
- Check if the parking assist monitor system is malfunctioning.
- CONFIRM MODEL
- Choose the model to be inspected.
Result
Result Proceed to w/o Parking Support Brake System A w/ Parking Support Brake System B
Result:
B
See step 4
Result:
A
See step 3
- Choose the model to be inspected.
- CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
Pre-procedure1
- Disconnect the C146 radio and display receiver assembly connector.
- Disconnect the M28 rear television camera assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Result C146-3 (CVO+) - M28-6 (CV+) Always Below 1 Ω Ω C146-4 (CVO-) - M28-5 (CV-) Always Below 1 Ω Ω C146-1 (GGND) - M28-3 (CGND) Always Below 1 Ω Ω C146-3 (CVO+) or M28-6 (CV+) - Body ground Always 10 kΩ or higher kΩ C146-4 (CVO-) or M28-5 (CV-) - Body ground Always 10 kΩ or higher kΩ C146-1 (GGND) or M28-3 (CGND) - Body ground Always 10 kΩ or higher kΩ Result
Proceed to OK NG
Post-procedure1
- None
Result:
OK
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to REMOVAL [10/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
- CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
Pre-procedure1
- Disconnect the C146 radio and display receiver assembly connector.
- Disconnect the M29 rear television camera assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition Result C146-3 (CVO+) - M29-6 (CV+) Always Below 1 Ω Ω C146-4 (CVO-) - M29-5 (CV-) Always Below 1 Ω Ω C146-1 (GGND) - M29-3 (CGND) Always Below 1 Ω Ω C146-3 (CVO+) or M29-6 (CV+) - Body ground Always 10 kΩ or higher kΩ C146-4 (CVO-) or M29-5 (CV-) - Body ground Always 10 kΩ or higher kΩ C146-1 (GGND) or M29-3 (CGND) - Body ground Always 10 kΩ or higher kΩ Result
Proceed to OK NG
Post-procedure1
- None
Result:
OK
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to REMOVAL [10/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR