Installation [10/2022 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Lexus RX 500h, 2025 Lexus RX 350, 2024 Lexus RX 500h, 2024 Lexus RX 350, and 2023 Lexus RX 500h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL KNOCK CONTROL SENSOR
*a Top *b Right of Vehicle *c 15° *d 5° - Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
NOTE:- If the knock control sensor has been struck or dropped, replace it.
- Make sure that the knock control sensor is in the correct position.
- Connect the knock control sensor connector.
- Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
- CONNECT WIRE HARNESS
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- INSTALL GENERATOR ASSEMBLY
Refer to INSTALLATION [10/2022 - ]
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the knock control sensor.
Refer to INITIALIZATION [10/2022 - ]
- Perform "Inspection After Repair" after replacing the knock control sensor.