LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 350h Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Engine Control System - Service Information) >> ENGINE COOLANT TEMPERATURE SENSOR (for Gasoline Model) >> Removal [10/2022 - ] >> Procedure

Removal [10/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Lexus RX 500h, 2025 Lexus RX 350, 2024 Lexus RX 500h, 2024 Lexus RX 350, and 2023 Lexus RX 500h. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN ENGINE COOLANT 

    Refer to REPLACEMENT [10/2022 - ]

  2. REMOVE ENGINE COOLANT TEMPERATURE SENSOR (for Outlet Side) 
    NOTE:

    If the engine coolant temperature sensor has been struck or dropped, replace it.
    1. GTY1076268Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE GENERATOR ASSEMBLY 

    HINT: 

    Perform this procedure only when replacement of the engine coolant temperature sensor (for Water Inlet Housing Side) is necessary.

    Refer to REMOVAL [10/2022 - ]

  4. DISCONNECT WIRE HARNESS 

    HINT: 

    Perform this procedure only when replacement of the engine coolant temperature sensor (for Water Inlet Housing Side) is necessary.

    1. GTY1077400Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. DISCONNECT NO. 2 INTERCOOLER COOLING WATER PIPE 

    HINT: 

    Perform this procedure only when replacement of the engine coolant temperature sensor (for Water Inlet Housing Side) is necessary.

    1. GTY1076276Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. DISCONNECT NO. 1 INTERCOOLER COOLING WATER PIPE 

    HINT: 

    Perform this procedure only when replacement of the engine coolant temperature sensor (for Water Inlet Housing Side) is necessary.

    1. GTY1076274Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR (for Water Inlet Housing Side) 
    NOTE:

    If the engine coolant temperature sensor has been struck or dropped, replace it.
    1. GTY1076275Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE INTAKE MANIFOLD WITH INTERCOOLER ASSEMBLY 

    HINT: 

    Perform this procedure only when replacement of the engine coolant temperature sensor (for Cylinder Head Side) is necessary.

    Refer to REMOVAL [10/2022 - ]

  9. REMOVE ENGINE COOLANT TEMPERATURE SENSOR (for Cylinder Head Side) 
    1. GTY1076474Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the engine coolant temperature sensor connector.
      2. Using SST, remove the engine coolant temperature sensor from the cylinder head sub-assembly.
        • SST: 09817-33191 
        NOTE:

        If the engine coolant temperature sensor has been struck or dropped, replace it.

      3. Remove the gasket from the engine coolant temperature sensor.
scientia non olet · About LEMON Manuals