Removal [10/2022 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Lexus RX 500h, 2025 Lexus RX 350, 2024 Lexus RX 500h, 2024 Lexus RX 350, and 2023 Lexus RX 500h. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE STARTER ASSEMBLY
Refer to REMOVAL [10/2022 - ]
- REMOVE CRANKSHAFT POSITION SENSOR
- Disconnect the crankshaft position sensor connector.
- Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.NOTE:
If the crankshaft position sensor has been struck or dropped, replace it.
- Perform this procedure only when reusing the crankshaft position sensor.
- Remove the O-ring from the crankshaft position sensor.
NOTE:- Make sure to only remove the O-ring with bare hands.
- When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
- If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.