Installation [10/2022 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Lexus RX 500h, 2025 Lexus RX 350, 2024 Lexus RX 500h, 2024 Lexus RX 350, and 2023 Lexus RX 500h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL CRANKSHAFT POSITION SENSOR
*1 O-ring - - *a Seam *b Crankshaft Position Sensor Tip *c OK *d NG - Perform this procedure only when reusing the crankshaft position sensor.
- Clean the O-ring groove of the crankshaft position sensor.NOTE:
Make sure the O-ring groove is free of foreign matter.
- Install a new O-ring to the crankshaft position sensor.NOTE:
Set the O-ring on the tip of the crankshaft position sensor and roll it into the O-ring groove with bare hands to install it.
- Check if the O-ring is twisted.
HINT:
Check the entire circumference of the seam of the O-ring for twisting.
- Clean the O-ring groove of the crankshaft position sensor.
- Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
- Using an 8 mm socket wrench, install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:- If the crankshaft position sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.
- Connect the crankshaft position sensor connector.
- Perform this procedure only when reusing the crankshaft position sensor.
- INSTALL STARTER ASSEMBLY
Refer to INSTALLATION [10/2022 - ]