LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 350h Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Engine Lubrication System - Service Information) >> Oil Pressure Sensor >> Removal [10/2022 - ] >> Procedure

Removal [10/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Lexus RX 500h, 2025 Lexus RX 350, 2024 Lexus RX 500h, 2024 Lexus RX 350, and 2023 Lexus RX 500h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT FENDER APRON SEAL RH 

    for 1Motor-HEV Model:

    Refer to PROCEDURE - Step 12

    for Gasoline Model:

    Refer to PROCEDURE - Step 14

  2. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY 
    1. GTY1131256Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the oil pressure sender gauge assembly connector.
      2. Using a 27 mm deep socket wrench, remove the oil pressure sender gauge assembly.
        NOTE:

        If the oil pressure sender gauge assembly is dropped or subjected to a strong impact, replace it with a new one.

scientia non olet · About LEMON Manuals