Installation [10/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Lexus RX 500h, 2025 Lexus RX 350, 2024 Lexus RX 500h, 2024 Lexus RX 350, and 2023 Lexus RX 500h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Oil Inlet Port	*b	3 Threads or More
	Adhesive Application Area	-	-

Apply adhesive to the area shown in the illustration.
Adhesive

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
NOTE:
- Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.
- Apply the adhesive to the first 3 threads or more of the oil pressure sender gauge assembly.
- Apply adhesive to the entire circumference of the thread.
Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.
Torque: 15 N.m (153 kgf/cm, 11 ft.lbf)

NOTE:
Do not start the engine within 1 hour of installation.
Connect the oil pressure sender gauge assembly connector.

INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6
CHECK ENGINE OIL LEVEL
for 1Motor-HEV Model:

Refer to PROCEDURE - Step 1

for Gasoline Model:

Refer to PROCEDURE - Step 1
INSTALL FRONT FENDER APRON SEAL RH
for 1Motor-HEV Model:

Refer to PROCEDURE - Step 77

for Gasoline Model:

Refer to PROCEDURE - Step 83