Installation [08/2023 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Set the EGR valve assembly to the camshaft housing.

      HINT: 

      At this time, do not install the parts with the bolts.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Using an 8 mm socket wrench, install the EGR valve assembly to the camshaft housing with the 2 bolts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *A

   for PHEV Model

   *B

   for HEV Model

   1. Using an 8 mm socket wrench, install the No. 1 EGR pipe sub-assembly to the intake manifold and EGR valve assembly with the 4 bolts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

• for PHEV Model:

  Refer to INSTALLATION [08/2023 - ]

• for HEV Model:

  Refer to INSTALLATION [10/2022 - ]

Refer to PROCEDURE - Step 6

1. If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.

   HINT: 

   Perform "Inspection After Repairs" after repairing or replacing the exhaust system.

   Refer to INITIALIZATION [10/2022 - ]