Removal [10/2022 - ]: Procedure

Refer to REMOVAL [10/2022 - ] 

Refer to PROCEDURE - Step 2

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Turning Direction

   -

   -

   1. Using SST, remove the rear No. 1 differential mount cushion.
      • SST: 09570-48010 
      NOTE:

      • Before using SST, apply grease to the SST bolts.
      • Be sure to use the correct combination of SST.
      • Be sure to use the correct direction of SST.
      • Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.
      • Do not tilt the bolts of SST.
      • Tighten the 2 bolts of SST so that they enter the 2 holes of the rear No. 1 differential mount cushion by an equal amount.