Removal [10/2022 - 08/2023]: Procedure
- PRECAUTION NOTE:
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
- REMOVE TONNEAU COVER ASSEMBLY
Refer to PROCEDURE - Step 1
- REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 2
- REMOVE BATTERY SERVICE COVER PLATE (except Gasoline Model)
Refer to PROCEDURE - Step 3
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
- for T24A-FTS (for Gasoline Model):
Refer to PROCEDURE - Step 2
- for T24A-FTS (for 1Motor-HEV Model):
Refer to PROCEDURE - Step 3
- for A25A-FXS:
Refer to PROCEDURE - Step 3
- for T24A-FTS (for Gasoline Model):
- REMOVE REAR SEAT CUSHION ASSEMBLY
Refer to PROCEDURE - Step 17 - REMOVE REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 18
- REMOVE REAR DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 20
- REMOVE NO. 3 BATTERY SERVICE COVER BOARD
Refer to PROCEDURE - Step 21
- REMOVE REAR DOOR SCUFF PLATE RH
Refer to PROCEDURE - Step 32
- REMOVE NO. 2 BATTERY SERVICE COVER BOARD
Refer to PROCEDURE - Step 33
- REMOVE BATTERY SERVICE COVER BOARD
Refer to PROCEDURE - Step 7
- REMOVE FOLD SEAT CONTROL ECU