SOC Gauge Malfunction [08/2023 - 10/2024]: Procedure
- CHECK CAN COMMUNICATION SYSTEM
- Check if CAN communication system DTCs are output.
Refer to DIAGNOSIS SYSTEM [08/2023 - 10/2024]
Result
Result Proceed to DTCs are not output A DTCs are output B
Result:
B
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2023 - ]
Result:
A
See step 2
- Check if CAN communication system DTCs are output.
- CHECK FOR DTC (PLUG-IN CHARGE CONTROL SYSTEM)
- Check if plug-in charge control system DTCs are output.
Powertrain > Plug-in Control > Trouble Codes
Result
Result Proceed to DTCs are not output A DTCs are output B
Result:
B
GO TO PLUG-IN CHARGE CONTROL SYSTEM. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2023 - ]
Result:
A
See step 3
- Check if plug-in charge control system DTCs are output.
- PERFORM ACTIVE TEST USING GTS
- Perform the Active Test according to the display on the GTS.
Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note SOC Gauge (MIN) SOC gauge
(SOC gauge indicates lower limit)ON See [Display 1] SOC Gauge (1/4) SOC gauge
(SOC gauge indicates 1/4)ON See [Display 1] SOC Gauge (1/2) SOC gauge
(SOC gauge indicates 1/2)ON See [Display 1] SOC Gauge (3/4) SOC gauge
(SOC gauge indicates 3/4)ON See [Display 1] SOC Gauge (MAX) SOC gauge
(SOC gauge indicates upper limit)ON See [Display 1] - HINT:
[Display 1]: SOC Gauge
*a SOC Gauge
(w/ Headup Display)*b SOC Gauge
(w/o Headup Display)*c Segments - - Refer to the following table for the specified SOC gauge position for each selected value:
Tester Display SOC Gauge Indication SOC Gauge
(MIN)Segments illuminate 0/8 SOC Gauge
(1/4)Segments illuminate 2/8 SOC Gauge
(1/2)Segments illuminate 4/8 SOC Gauge
(3/4)Segments illuminate 6/8 SOC Gauge
(MAX)Segments illuminate 8/8
Body Electrical > Combination Meter > Active Test
Tester Display SOC Gauge (MIN) Body Electrical > Combination Meter > Active Test
Tester Display SOC Gauge (1/4) Body Electrical > Combination Meter > Active Test
Tester Display SOC Gauge (1/2) Body Electrical > Combination Meter > Active Test
Tester Display SOC Gauge (3/4) Body Electrical > Combination Meter > Active Test
Tester Display SOC Gauge (MAX) Result
Result Proceed to Active Test can be performed correctly A Active Test cannot be performed correctly B - HINT:
Result:
A
GO TO PLUG-IN CHARGE CONTROL SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2023 - ]
Result:
B
REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [10/2022 - 10/2024]
- Perform the Active Test according to the display on the GTS.