Inspection [10/2022 - ]: Procedure
- INSPECT TRIP SWITCH
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Trip Switch)Standard Resistance
Tester Connection Condition Specified Condition Result C75-5 (RV) - C75-7 (E) Light control rheostat up switch pressed Below 50 Ω Ω C75-5 (RV) - C75-7 (E) Light control rheostat up switch not pressed 10 kΩ or higher kΩ C75-5 (RV) - C75-7 (E) Light control rheostat down switch pressed 1.71 to 1.89 kΩ kΩ C75-5 (RV) - C75-7 (E) Light control rheostat down switch not pressed 10 kΩ or higher kΩ C75-4 (A/B) - C75-7 (E) ODO/TRIP switch pressed Below 50 Ω Ω C75-4 (A/B) - C75-7 (E) ODO/TRIP switch not pressed 10 kΩ or higher kΩ If the result is not as specified, replace the trip switch.
- Illumination Inspection
*a Component without harness connected
(Trip Switch)Apply auxiliary battery voltage to the trip switch and check that it illuminates.
OK
Tester Connection Specified Condition Auxiliary battery positive (+) → C75-3 (ILL+)
Auxiliary battery negative (-) → C75-8 (ILL-)Illuminates If the result is not as specified, replace the trip switch.
- Measure the resistance according to the value(s) in the table below.