Removal [09/2014 - 10/2015]: Procedure

Refer to PROCEDURE - Step 1

Refer to REMOVAL [09/2014 - 11/2017]

Refer to PROCEDURE - Step 11

Refer to PROCEDURE - Step 12

1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor and magnetic clutch.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
   NOTE:

   Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

1. Remove the bolt and disconnect the suction hose from the compressor and magnetic clutch.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the O-ring from the suction hose.
   NOTE:

   Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

1. Disconnect the 2 connectors.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Disengage the clamp.
3. Remove the 3 bolts and nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

4. Using an E8 "TORX" socket wrench, remove the stud bolt and compressor and magnetic clutch.

   HINT: 

   Remove the compressor and magnetic clutch from the vehicle with the stud bolt remaining in the compressor and magnetic clutch.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002