Inspection [09/2014 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT TRANSMISSION WIRE
*a Component without harness connected
(Transmission Wire (ATF Temperature Sensor))- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Specified Condition 9 (OIL) - 1 (E2) 79 Ω to 156 kΩ 9 (OIL) - Body ground 10 kΩ or higher 1 (E2) - Body ground 10 kΩ or higher HINT:
If the result is not as specified at any of the ATF temperatures shown in the following table, the driveability of the vehicle may decrease.
Standard Resistance
Tester Connection ATF Temperature Specified Condition 9 (OIL) - 1 (E2) 10°C (50°F) 5 to 8 kΩ 9 (OIL) - 1 (E2) 25°C (77°F) 2.5 to 4.5 kΩ 9 (OIL) - 1 (E2) 110°C (230°F) 0.22 to 0.28 kΩ If the result is not as specified, replace the transmission wire (ATF temperature sensor).
- Measure the resistance according to the value(s) in the table below.