LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RC 350 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission System (A760H) - Service Information (1 Of 2)) >> Park / Neutral Position Switch >> Adjustment [09/2014 - ] >> Procedure

Adjustment [09/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Move the shift lever to N.
    2. Remove the bolt from the park/neutral position switch assembly.
      GTY465342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Neutral Basic Line
      *b Groove
    3. Clean the bolt and bolt hole.
    4. Align the neutral basic line with the groove as shown in the illustration.
    5. Apply adhesive to 2 or 3 threads on the end of the bolt.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    6. Hold the park/neutral position switch assembly in that position and tighten the bolt.

      Torque: 12.8 N.m (131 kgf/cm, 9 ft.lbf) 

    7. After the adjustment, perform the park/neutral position switch assembly operation check.

      See step  1

scientia non olet · About LEMON Manuals