Typical Enabling Conditions
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus RC 300, 2023 Lexus RC 300, 2022 Lexus RC 300, 2021 Lexus RC 300, and 2020 Lexus RC 300. However, it is still accessible from the selected car via links, so may be relevant.
STUCK MONITOR
| Monitor runs whenever the following DTCs are not stored | None |
| All of the following conditions are met | 4 seconds or more |
| Engine coolant temperature sensor malfunction | Not detected |
| Intake air temperature sensor (mass air flow meter sub-assembly) malfunction | Not detected |
| Fuel pressure sensor (for low pressure side) circuit malfunction | Not detected |
| Atmospheric pressure sensor malfunction | Not detected |
| Battery voltage | 11 V or higher |
| Fuel cut | Off |
CORRELATION MONITOR (FUEL CUT)
| Monitor runs whenever the following DTCs are not stored | None |
| All of the following conditions are met | - |
| Engine coolant temperature sensor malfunction | Not detected |
| Intake air temperature sensor (mass air flow meter sub-assembly) malfunction | Not detected |
| Fuel pressure sensor (for low pressure side) circuit malfunction | Not detected |
| Atmospheric pressure sensor malfunction | Not detected |
| Battery voltage | 11 V or higher |
| Engine coolant temperature | 75°C (167°F) or higher |
| Intake air temperature (for mass air flow meter sub-assembly) | -10°C (14°F) or higher |
| Atmospheric pressure | 76 kPa (abs) [11 psi (abs)] or higher |
| Fuel cut | On |
| Fuel pump operation at maximum duty | 1 second or more |