Typical Enabling Conditions
WARNING: This page is about a different car, the 2017 Lexus RC 350, 2017 Lexus RC 300, 2016 Lexus RC 350, 2016 Lexus RC 300, and 2015 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
ALL
| Monitor runs whenever the following DTCs are not stored | None |
STUCK MONITOR
| All of the following conditions are met | - |
| Engine coolant temperature sensor malfunction | Not detected |
| High pressure fuel pump malfunction | Not detected |
| Fuel pressure sensor circuit malfunction | Not detected |
| Soak timer malfunction | Not detected |
| Battery voltage | 11 V or higher |
| Fuel cut | Off |
| High pressure fuel pump | Driving |
| Injection mode | NOT PFI (Port fuel injection) |
CORRELATION MONITOR WITH BAROMETRIC PRESSURE
| All of the following conditions are met | - |
| Engine coolant temperature sensor malfunction | Not detected |
| High pressure fuel pump malfunction | Not detected |
| Fuel pressure sensor circuit malfunction | Not detected |
| Soak timer malfunction | Not detected |
| Battery voltage | 8 V or higher |
| Engine switch | Off |
| Soak time | 5, 7 or 9.5 hours |
| Atmospheric pressure | 70 kPa (abs) [525 mmHg (abs)] or higher |