Typical Enabling Conditions
WARNING: This page is about a different car, the 2017 Lexus RC 350, 2017 Lexus RC 300, 2016 Lexus RC 350, 2016 Lexus RC 300, and 2015 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
ALL
| Monitor runs whenever the following DTCs are not stored | None |
P0335: CRANKSHAFT POSITION SENSOR RANGE CHECK/RATIONALITY
| All of the following conditions are met | - |
| Crankshaft position sensor | Signal input |
| Engine switch | On (IG) |
| Time after starter off to on | 3 seconds or more |
| VVT sensor circuit fail | Not detected |
| Number of VVT sensor signal pulse | 6 times |
| Battery voltage | 7 V or higher |
| Minimum battery voltage while starter on | Less than 11 V |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 1)
| All of the following conditions are met | - |
| Engine speed | 600 rpm or higher |
| Starter | Off |
| Time after starter on to off | 3 seconds or more |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 2)
| Both of the following conditions are met | - |
| Starter | On |
| Minimum battery voltage while starter on | Less than 11 V |