DTC P0010-13: A Camshaft Position Actuator Bank 1 Circuit Open [10/2015 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus RC 300, 2023 Lexus RC 300, 2022 Lexus RC 300, 2021 Lexus RC 300, and 2020 Lexus RC 300. However, it is still accessible from the selected car via links, so may be relevant.
- READ OUTPUT DTC (DTC P0010-13)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Clear the DTC after recording the freeze frame data and DTC.
Powertrain > Engine > Clear DTCs
- Turn the engine switch off and wait for at least 30 seconds.
- Start the engine.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0010-13 is output A DTCs are not output B
Result:
B
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [10/2015 - ]
Result:
A
See step 2
- INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY
- Inspect the cam timing oil control solenoid assembly.
Refer to INSPECTION [10/2015 - ]
Result
Proceed to OK NG
Result:
NG
REPLACE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY. Refer to REMOVAL [10/2015 - ]
Result:
OK
See step 3
- Inspect the cam timing oil control solenoid assembly.
- CHECK HARNESS AND CONNECTOR (CAM TIMING OIL CONTROL SOLENOID ASSEMBLY - ECM)
- Disconnect the cam timing oil control solenoid assembly connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition F77-2 - F67-9 (OC1+) Always Below 1 Ω F77-1 - F67-8 (OC1-) Always Below 1 Ω F77-2 or F67-9 (OC1+) - Body ground and other terminals Always 10 kΩ or higher F77-1 or F67-8 (OC1-) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [10/2015 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR