LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RC 350 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Cooling System (2GR-FSE) - Service Information) >> Thermostat >> Installation [09/2014 - 11/2017] >> Procedure

Installation [09/2014 - 11/2017]: Procedure

WARNING: This page is about a different car, the 2017 Lexus RC 350, 2017 Lexus RC 300, 2016 Lexus RC 350, 2016 Lexus RC 300, and 2015 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 
    1. Install a new gasket and the water inlet with thermostat sub-assembly with the 3 nuts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

  2. CONNECT NO. 6 WATER BY-PASS HOSE 
    1. Connect the No. 6 water by-pass hose to the water inlet and slide the clip to secure it.
  3. CONNECT NO. 2 RADIATOR HOSE 
    1. Connect the No. 2 radiator hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
  4. INSTALL INLET NO. 1 AIR CLEANER 

    Refer to PROCEDURE - Step 86 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 87 [10/2015 - 11/2017]

  5. ADD ENGINE COOLANT 

    See step  6 [09/2014 - 10/2015], or see step  6 [10/2015 - 11/2017]

  6. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  7. INSTALL CENTER NO. 4 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 9 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 9 [10/2015 - 11/2017]

  8. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 117 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 118 [10/2015 - 11/2017]

  9. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 2

  10. INSTALL ENGINE ROOM SIDE COVER 

    Refer to PROCEDURE - Step 3

scientia non olet · About LEMON Manuals