Installation [09/2014 - 11/2017]: Procedure

WARNING: This page is about a different car, the 2017 Lexus RC 350, 2017 Lexus RC 300, 2016 Lexus RC 350, 2016 Lexus RC 300, and 2015 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

NOTE:

Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Adhesive 1324

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

Type A

Torque: 14.7 N.m (150 kgf/cm, 11 ft.lbf)

Type B

Torque: 15 N.m (153 kgf/cm, 11 ft.lbf)

NOTE:

Do not start the engine within 1 hour of installation.

*A	Type A
*B	Type B

Connect the engine oil pressure switch assembly connector.

ADD ENGINE OIL
See step 7 [09/2014 - 10/2015], or see step 7 [10/2015 - 11/2017]
INSPECT ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1
INSPECT FOR ENGINE OIL LEAK
See step 8 [09/2014 - 10/2015], or see step 8 [10/2015 - 11/2017]
INSTALL INLET NO. 1 AIR CLEANER
Refer to PROCEDURE - Step 86 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 87 [10/2015 - 11/2017]
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 2
INSTALL ENGINE ROOM SIDE COVER
Refer to PROCEDURE - Step 3