LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RC 350 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Engine Starting System (2GR-FSE) - Service Information) >> Relay >> On-Vehicle Inspection [10/2015 - 11/2017] >> Procedure

On-Vehicle Inspection [10/2015 - 11/2017]: Procedure

WARNING: This page is about a different car, the 2017 Lexus RC 350, 2017 Lexus RC 300, 2016 Lexus RC 350, 2016 Lexus RC 300, and 2015 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ST NO. 1 RELAY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY509439Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the ST NO. 1 relay.

scientia non olet · About LEMON Manuals