DTC U0073: Control Module Communication Bus OFF; DTC U0100: Lost Communication with ECM / PCM "A"; DTC U0101: Lost Communication with TCM; DTC U0129: Lost Communication with Brake System Control Module; DTC U0142: Lost Communication with Body Control Module "B"; DTC U0155: Lost Communication with Instrument Panel Cluster (IPC) Control Module [11/2017 - 10/2018]: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Lexus RC 350, 2018 Lexus RC 300, 2017 Lexus RC 350, 2017 Lexus RC 300, and 2017 Lexus RC 200t. However, it is still accessible from the selected car via links, so may be relevant.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
- Clear the DTCs.
Body Electrical > HL AutoLeveling > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 2
- CHECK FOR DTC
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
- Check for DTCs.
Body Electrical > HL AutoLeveling > Trouble Codes
OK
DTCs are not output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - 10/2018]
Result:
NG
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - 10/2018]