Inspection [10/2015 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus RC 300, 2023 Lexus RC 300, 2022 Lexus RC 300, 2021 Lexus RC 300, and 2020 Lexus RC 300. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT VACUUM REGULATING VALVE ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 11.1 to 12.5 Ω 1 - Vacuum regulating valve assembly body ground Always 10 MΩ or higher 2 - Vacuum regulating valve assembly body ground 10 MΩ or higher If the result is not as specified, replace the vacuum regulating valve assembly.
- Check the operation of the vacuum regulating valve assembly.
- Using a vacuum pump, apply a vacuum of 67 kPa (503 mmHg, 19.8 in. Hg) to the port (F) and check that the vacuum regulating valve operates normally.
*a Port (E) *b Port (F) *c Air - Check that air flows from the filter when air is blown into the port (E).
HINT:
When air is blown into the port (E), the vacuum of the port (F) decreases.
- Apply battery voltage between the terminals, and check that air flows from the port (F) when air is blown into the port (E).
*a Port (E) *b Port (F) *c Air
- Using a vacuum pump, apply a vacuum of 67 kPa (503 mmHg, 19.8 in. Hg) to the port (F) and check that the vacuum regulating valve operates normally.
- Measure the resistance according to the value(s) in the table below.