DTC P023A-00: Charge Air Cooler Coolant Pump Control Circuit/Open; DTC P023A-71: Charge Air Cooler Coolant Pump Control Actuator Stuck [10/2015 - ]: Procedure
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P023A-00 OR P023A-71)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P023A-00 or P023A-71 is output A DTC P023A-00 or P023A-71 and other DTCs are output B HINT:
If any DTCs other than P023A-00 or P023A-71 are output, troubleshoot those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2015 - 08/2016] , or refer to DIAGNOSTIC TROUBLE CODE CHART [08/2016 - 11/2017] , or refer to DIAGNOSTIC TROUBLE CODE CHART [11/2017 - 10/2018] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2018 - 11/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [11/2019 - 09/2020] , or refer to DIAGNOSTIC TROUBLE CODE CHART [09/2020 - 10/2022] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2022 - ]
Result:
A
See step 2
- PERFORM ACTIVE TEST USING TECHSTREAM (CONTROL THE INTERCOOLER WATER PUMP)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.NOTE:
Be sure to perform the inspection with the battery voltage at 11 V or higher.
HINT:
If the battery voltage is low, the electric water pump assembly may stop operating.
- Enter the following menus: Powertrain / Engine / Active Test / Control the Intercooler Water Pump / Data List / Intercooler Water Pump Speed.
Powertrain > Engine > Active Test
Active Test Display Control the Intercooler Water Pump Data List Display Intercooler Water Pump Speed - According to the display on the Techstream, read the Data List while the Active Test "Control the Intercooler Water Pump" is set to 85%.
Result
Techstream Operation Intercooler Water Pump Speed Proceed to 85% 4000 rpm or less A 7000 rpm or higher B Other than above C HINT:
- If the electric water pump assembly voltage is extremely high or low, control may be temporarily stopped and a DTC stored.
- The coolant will freeze at -15°C (5°F) at 30% coolant concentration and at -35°C (-31°F) at 50% coolant concentration.
- DTC P023A-71 will be stored if the electric water pump assembly cannot rotate due to freezing of the coolant.
- If DTC P023A-71 is stored due to freezing of the coolant, the problem cannot be reproduced. Judge whether freezing of the coolant occurred from the coolant replacement history and the ambient temperature when the DTC was stored.
Result:
B
See step 4
Result:
C
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [10/2015 - ]
Result:
A
See step 3
- REPLACE ELECTRIC WATER PUMP ASSEMBLY
- Replace the electric water pump assembly.
Refer to REMOVAL [10/2015 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 8
- Replace the electric water pump assembly.
- CHECK COOLANT LEVEL AT RESERVOIR
- Check the coolant (for intercooler) level.
Refer to PROCEDURE - Step 2
Result
Result Proceed to At or below reservoir tank LOW level A At or above reservoir tank LOW level B
Result:
B
See step 7
Result:
A
See step 5
- Check the coolant (for intercooler) level.
- CHECK FOR COOLANT LEAK
- Check the turbocharger and intercooler cooling system for coolant leaks.
Refer to PROCEDURE - Step 1
OK
No leaks in turbocharger and intercooler cooling system.
Result
Proceed to OK NG
Result:
OK
See step 7
Result:
NG
See step 6
- Check the turbocharger and intercooler cooling system for coolant leaks.
- REPAIR COOLANT LEAK
Result:
NEXT
See step 7
- BLEED AIR
- Bleed the air and add coolant up to the FULL Line on the reservoir tank.
Refer to REPLACEMENT [10/2015 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 8
- Bleed the air and add coolant up to the FULL Line on the reservoir tank.
- PERFORM ACTIVE TEST USING TECHSTREAM (CONTROL THE INTERCOOLER WATER PUMP)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.NOTE:
Be sure to perform the inspection with the battery voltage at 11 V or higher.
HINT:
If the battery voltage is low, the electric water pump assembly may stop operating.
- Enter the following menus: Powertrain / Engine / Active Test / Control the Intercooler Water Pump / Data List / Intercooler Water Pump Speed.
Powertrain > Engine > Active Test
Active Test Display Control the Intercooler Water Pump Data List Display Intercooler Water Pump Speed - According to the display on the Techstream, read the Data List while the Active Test "Control the Intercooler Water Pump" is set to 85%.
OK
The value of Intercooler Water Pump Speed is 4000 to 7000 rpm.
Result
Proceed to NEXT
Result:
NEXT
END