Inspection [10/2015 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus RC 300, 2023 Lexus RC 300, 2022 Lexus RC 300, 2021 Lexus RC 300, and 2020 Lexus RC 300. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT OIL PRESSURE SWITCHING VALVE ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 13 to 17 Ω If the result is not as specified, replace the oil pressure switching valve assembly.
*a Component without harness connected
(Oil Pressure Switching Valve Assembly) - Connect a battery positive (+) lead to terminal 1 and a negative (-) lead to terminal 2.
Check that a clicking sound is heard from the oil pressure switching valve assembly.
*a Component without harness connected
(Oil Pressure Switching Valve Assembly)NOTE:- Perform this test within 10 seconds to prevent the coil from burning out.
- Always switch the voltage on and off at the battery side, not the oil pressure switching valve assembly side.
If the result is not as specified, replace the oil pressure switching valve assembly.
- Measure the resistance according to the value(s) in the table below.