Inspection [10/2015 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus RC 300, 2023 Lexus RC 300, 2022 Lexus RC 300, 2021 Lexus RC 300, and 2020 Lexus RC 300. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT FUEL SENDER GAUGE ASSEMBLY
- Check that the float moves smoothly between F and E.
*a Component without harness connected
(Fuel Sender Gauge Assembly) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Float Level Specified Condition 1 - 2 F 6.5 to 8.5 Ω Between F and E 6.5 to 199.4 Ω (Gradually changes) E 194.4 to 199.4 Ω - If the result is not as specified, replace the fuel sender gauge assembly.
- Check that the float moves smoothly between F and E.
- INSPECT NO. 2 FUEL SENDER GAUGE ASSEMBLY
- Check that the float moves smoothly between F and E.
*a Component without harness connected
(No. 2 Fuel Sender Gauge Assembly) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Float Level Specified Condition 1 - 2 F 6.5 to 8.5 Ω Between F and E 6.5 to 216.1 Ω (Gradually changes) E 210.1 to 216.1 Ω - If the result is not as specified, replace the No. 2 fuel sender gauge assembly.
- Check that the float moves smoothly between F and E.