LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RC 350 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Fuel System (2GR-FSE) - Service Information) >> Fuel Pump Ecu >> Installation [10/2015 - 11/2017] >> Procedure

Installation [10/2015 - 11/2017]: Procedure

WARNING: This page is about a different car, the 2017 Lexus RC 350, 2017 Lexus RC 300, 2016 Lexus RC 350, 2016 Lexus RC 300, and 2015 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL PUMP CONTROL ECU ASSEMBLY 
    1. Install the fuel pump control ECU assembly to the vehicle body with the 2 nuts.

      Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

      NOTE:

      Do not reuse the fuel pump control ECU assembly if it has been dropped or subjected to a severe impact.

    2. Engage the clamp to connect the wire harness to the fuel pump control ECU assembly.
    3. Connect the fuel pump control ECU assembly connector.
    4. Engage the clamp to install the luggage compartment trim side cover LH.
      GTY509209Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Install the 3 clips (A).
    6. Install a new clip (B).
    7. Install the 2 rope hook assemblies with the 2 bolts.
    8. Engage the 4 claws to close the 2 covers.
  2. INSTALL FRONT UPPER LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 9

  3. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 2

  4. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 14

  5. INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 15

  6. INSTALL SPARE WHEEL COVER TRAY 

    Refer to PROCEDURE - Step 16

  7. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 17

scientia non olet · About LEMON Manuals