LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RC 350 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Control System (8AR-FTS) - Service Information) >> Heated Oxygen Sensor >> Inspection [10/2015 - ] >> Procedure

Inspection [10/2015 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus RC 300, 2023 Lexus RC 300, 2022 Lexus RC 300, 2021 Lexus RC 300, and 2020 Lexus RC 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT HEATED OXYGEN SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      GTY651939Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Heated Oxygen Sensor)

      Standard Resistance

      Tester Connection Condition Specified Condition
      2 (+B) - 1 (HT1B) 20°C (68°F) 9 to 14 Ω
      1 (HT1B) - 4 (E2) Always 10 kΩ or higher

      If the result is not as specified, replace the heated oxygen sensor.

scientia non olet · About LEMON Manuals