LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RC 350 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Control System (8AR-FTS) - Service Information) >> Accelerator Pedal >> Installation [10/2015 - ] >> Procedure

Installation [10/2015 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus RC 300, 2023 Lexus RC 300, 2022 Lexus RC 300, 2021 Lexus RC 300, and 2020 Lexus RC 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ACCELERATOR PEDAL ASSEMBLY 
    1. Install the accelerator pedal assembly with the 2 bolts.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

  2. INSTALL ACCELERATOR PEDAL PAD 
    1. Engage the 2 claws to install the accelerator pedal pad.
  3. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY 
    NOTE:
    • Avoid physical shock to the accelerator pedal sensor assembly.
    • Do not disassemble the accelerator pedal sensor assembly.
    • This accelerator pedal sensor assembly does not require lubrication.
    • Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.
    1. Install the rod of the accelerator pedal sensor assembly to the accelerator pedal assembly.
    2. Install the accelerator pedal sensor assembly with the 2 nuts.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    3. Connect the accelerator pedal sensor assembly connector.
scientia non olet · About LEMON Manuals